Aller au contenu

  2. → Affichage d'un profil: Messages: mr45revolver

mr45revolver

Inscrit(e) : 26 déc. 2011
Hors-ligne Dernière activité : janv. 06 2012 03:26
-----

Messages que j'ai posté

Dans le sujet : Slim wont glitch or boot after flash stock nand back

04 janvier 2012 - 22:01

Like to say thanks to all they guys here that helped out, finally got my console up and running.

Dans le sujet : Slim wont glitch or boot after flash stock nand back

27 décembre 2011 - 01:37

You should have two wire to pin 9-10 http://www.logic-sun...nu/H-slim50.png
I only see one



i had two but after looking at the diagram i had 8-9 wired to the board not 9-10 this was the mistake i made by not double checking my wiring and is what shorted out the console most likely..

I have since checked the nand a few times , and what is being copied to the nand matches my dumps without error. So there must be a short somewhere on the motherboard leaving this console dead in the water. I will probally just pay the $99 for M$ to repair it instead of trying to chase down the fault.

Dans le sujet : Slim wont glitch or boot after flash stock nand back

26 décembre 2011 - 23:40

tbh i did the RGH on fat and slim with the digilent cpld and it works great ... you don't really need a dedicated RGH chip
If you get a red light with stock image, you probably have a short somewhere...



Is the wiring for the ground and the CPU glitch coming off the CPLD i have pictured similar to what you have done? If so i am going to try welding this on another slim. I just dont want to kill another console

Dans le sujet : Slim wont glitch or boot after flash stock nand back

26 décembre 2011 - 23:04

Ok so , I think the best for you is to restart on a clean with a "real" chip, like coolrunner or 360glitchchip.
this will prevent the supposed problem of change CPLD ect ...


Yeah i am waiting on the TX coolrunner to ship. I would still like to get this console to boot with stock nand if at all possible.

Dans le sujet : Slim wont glitch or boot after flash stock nand back

26 décembre 2011 - 22:28

Hello

do you have a picture of your installation

thank you



I removed it all , and tried to reflash the stock nand image. The pictures i do have are of the CPLD. I used a 270pf cap but not shure if soldering the ground and glitch wire to the cap are correct.

  1. LS forums
  2. → Affichage d'un profil: Messages: mr45revolver
  3. Privacy Policy